New Holland T4.75F Operator's Manual page 70

Changing 12 or 24 hour clock format
If you want to display the set time in 12 or 24 hour mode,
follow these instructions:
Turn the ignition key onto the first click, holding down the
symbol (B) on the switch for more than three seconds.
• The central display shows "SETUP MENU" as in detail
(1). Release the symbol (B) to go to detail (2) CAL.
Press the arrow (D) to reach the word "SET" as on the
screen of detail (3).
• Press the arrow (C)or (D) and the display will show "12/
24" as in detail (4).
• Press the symbol (B) and the display will show the last
setting made, with one arrow in the direction of 12 or
24 as shown in details (5) and (6). If you want to stop
the selection, press the symbol (A)on the switch to go
back automatically to the view as in detail (4). Press
the same symbol again to exit the programming menu.
If you want to proceed, press the arrow (C) on the switch
to pass from "24" to "12" or on the arrow (D) to pass
from "12" to "24" as shown in details (7) and (8).
• In both cases, press the symbol (B) and the display will
show the selection blinking, as shown in details (7) or
(8). Wait approximately two seconds to save the set-
ting. the blinking will stop to confirm saving.
3 - CONTROLS/INSTRUMENTS
3-32
3
MOIL13TR00554CA