New Holland T4.75F Operator's Manual page 74

Active fault codes display
If you want to display the active fault codes, proceed as
follows.
Turn the ignition key onto the first click, holding down the
symbol (B) on the switch for more than three seconds.
• The central display shows "SETUP MENU" as in detail
(1). Release the symbol (B) and after approximately
two seconds the display will show "CAL", as in detail
(2).
• Now press the arrow (C) on the switch to display the
symbol as in detail (3).
• Press the symbol (B) on the switch to display the active
fault codes
NOTE: The current fault codes are displayed in se-
quence. Each code is displayed blinking for 4 seconds
as in detail (4).
If you want to stop the display, press the symbol (A) on
the switch. This will automatically take you back to the
display as in detail (3). Press the same symbol again to
exit the programming menu.
3 - CONTROLS/INSTRUMENTS
3-36
7
MOIL13TR00550CA