Side Hydraulic Valves - New Holland T4.75F Operator's Manual

Side hydraulic valves

Only models with roll bars ROPS
WARNING
Pressurized system!
Before disconnecting the couplers, you must:
-lower the connected attachments,
-stop the engine,
-move the control levers forward and backward to discharge pressure from the hydraulic system.
Failure to comply could result in death or serious injury.
WARNING
Pressurized fluid can penetrate the skin and cause severe injuries.
Keep hands and body away from any pressurized leak. DO NOT use your hand to check for leaks. Use
a piece of cardboard or paper. If fluid penetrates the skin, seek medical attention immediately.
Failure to comply could result in death or serious injury.
There are two distributors (1) figure 2 for fitting side or
front implements.
The distributors are controlled by the levers (2) and (3)
that command the rear distributors with the "DIVERTER"
function, that is to say by pressing the button (6).
With connected implements working with their own hy-
draulic motor, connect the outlet pipe to the socket (2) fig-
ure 2 for rapid oil discharge.
Operation
The levers shown in the figure, equipped with buttons
(6), can separately govern a number of implements
connected as described below:
• Move the levers forwards to lower or backwards to raise
the implements connected to the rear distributors with-
out using the buttons (6).
• Press the buttons (6) and move the levers forwards to
lower or backwards to raise the implements connected
to the side distributors.
6 - WORKING OPERATIONS
6-12
1
MOIL13TR00452AA
2
MOIL13TR00610AA
W0389A
W0158A