New Holland T4.75F Operator's Manual page 24

5. When towing, do not negotiate bends with the differen-
tial lock engaged as this may prevent you from steer-
ing the tractor.
Use of implements and agricultural machin-
ery
1. Do not connect implements or machinery that require
more power than can be generated by your tractor
model.
2. Never negotiate sharp bends with the power take-
off under a heavy load; this may damage the univer-
sal joints on the transmission shaft connected to the
power take-off.
3. Never stand between the reversing tractor and the im-
plement when hitching.
4. When using implements that require the tractor to be
stationary with the engine running, keep the gear and
range levers in the neutral position, apply the hand-
brake and use suitable wheel chocks.
5. Do not operate machines connected to the power
take-off without first ensuring that the operating range
of the machine is free of bystanders. Also check that
all rotating parts connected to the power take-off shaft
are correctly protected.
6. Add rear ballast when using lifting equipment fitted to
the front of the tractor.
2 - SAFETY INFORMATION
8
DCSFTNEGB008S1A
9
DCSFTNEGB009S1A
Stopping the tractor
1. When the tractor is stationary, never leave connected
implements in the raised position. All implements
must be lowered before stopping the engine.
2. Before leaving the driving position, move the gear
lever to the neutral position, disengage the power
take-off, apply the handbrake and stop the engine.
Always remove the ignition key from the dashboard
when leaving the tractor unattended.
3. Park on flat surfaces, where possible, and apply the
handbrake before leaving the tractor.
ground, besides applying the hand brake, as an ad-
ditional safety measure, use wheel chocks (available
as an optional); this procedure is compulsory when
parking with a trailer hitched.
Servicing the tractor
WARNING
1.
Illustrations in this manual may show pro-
tective shielding open or removed to bet-
ter illustrate a particular feature or adjust-
ment.
Replace all shields before operating the
machine.
Failure to comply could result in death or
serious injury.
Do not work on the tyres with unsuitable equipment
or without the necessary experience. Incorrect tyre
fitting may put safety at risk. If in doubt, contact
skilled personnel.
2. When changing or storing tyres, make sure they are
stacked correctly and cannot roll or topple over caus-
ing personal injury.
3. Before removing any hydraulic tubing, check that the
system is not pressurised.
2-4
On sloping
10
DCSFTNEGB010S1A
W0012A