High-Speed Counter 1 Circular Max. Count (Ring Counter Maximum Value); High-Speed Counter 1 Reset Method; High-Speed Counter 1 Pulse Input Setting (Pulse Input Mode) - Omron CJ1M-CPU21 Operation Manual

PLC Setup Settings

High-speed Counter 1 Circular Max. Count (Ring Counter Maximum Value)

Programming Settings
Console setting
address
Word Bits
54 00 to 15 00000000 to
FFFFFFFF hex
(See note.)
55 00 to 15

High-speed Counter 1 Reset Method

Programming Settings
Console setting
address
Word Bits
53 04 to 07 0 hex: Z phase,
software reset
(stop comparing)
1 hex: Software
reset (stop com-
paring)
2 hex: Z phase,
software reset
(continue com-
paring)
3 hex: Software
reset (continue
comparing)

High-speed Counter 1 Pulse Input Setting (Pulse Input Mode)

Programming Settings
Console setting
address
Word Bits
53 00 to 03 0 hex: Differential
phase inputs
1 hex: Pulse +
direction inputs
2 hex: Up/Down
inputs
3 hex: Increment
pulse input
Default
Sets the max. ring count for high-
00000000
hex
speed counter 1.
When the high-speed counter 1
counting mode is set to ring mode,
the count will be reset to 0 automati-
cally when the counter PV exceeds
the max. ring count.
Default
0 hex Specifies the reset method for high-
speed counter 1.
Default
0 hex Specifies the pulse-input method for
high-speed counter 1.
Note When the CX-Programmer is being used to make the setting, the setting is
input in decimal.
Function
Area flags/
A272
(Rightmost 4
digits of the
high-speed
counter 1
PV)
A273
(Leftmost 4
digits of the
high-speed
counter 1
PV)
Function
Area flags/
---
Function
Area flags/
---
Section 4-2
Related Time when
Auxiliary setting is read
by CPU Unit
bits
When operation
starts
Related Time when
Auxiliary setting is read
by CPU Unit
bits
When power is
turned ON
Related Time when
Auxiliary setting is read
by CPU Unit
bits
When power is
turned ON
55