30/ENGINE ASSEMBLY
Installing the clutch cover
20.21
Installing the water pump cover
20.22
Installing the ignition pulse generator
20.23
–
Mount dowels
300320-11
–
Mount the clutch cover.
Info
Turn the water pump impeller slightly in order to engage the water pump
drive.
–
Mount screws
mounted.
Guideline
Screw, clutch cover
300319-11
–
Mount screws
mounted.
Guideline
Screw, clutch cover
–
Mount screw
Guideline
Screw, clutch cover
–
Position the crankshaft at top dead center (TDC) and block using the special tool.
Crankshaft locking bolt (113080802) (
–
Put the water pump cover seal in place.
–
Put the water pump cover on. Mount screws
pump cover screws have been mounted.
Guideline
Screw, water pump cover
–
Mount screw
Guideline
Screw, water pump cover
300318-11
–
Position the ignition pulse generator.
–
Mount and tighten screws
Guideline
Screw, ignition pulse gen-
erator
–
Position the cable and insert the cable support sleeve into the engine case.
300317-10
. Put clutch cover gasket
and tighten once all of the clutch cover screws have been
and tighten once all of the clutch cover screws have been
and tighten all screws in a crisscross pattern.
and tighten all screws in a crisscross pattern.
.
M5
in place.
M6x25
10 Nm (7.4 lbf ft)
M6x30
10 Nm (7.4 lbf ft)
M6x65
10 Nm (7.4 lbf ft)
p. 267)
and tighten once all of the water
M6x25
10 Nm (7.4 lbf ft)
M6x55
10 Nm (7.4 lbf ft)
6 Nm
Loctite
®
(4.4 lbf ft)
143
243™