30/ENGINE - WORK ON THE INDIVIDUAL PARTS
Removing the oil pressure regulator valve
19.3
Checking the spring length of the oil pressure regulator valve
19.4
Installing the oil pressure regulator valve
19.5
Removing the crankshaft seal ring in the clutch cover
19.6
–
Press countershaft shaft seal ring
facing inward.
–
Mount and tighten oil jet
Guideline
Oil jet, piston cooling
–
Mount the dowels.
–
Blow out all oil holes with compressed air and check that they are clear.
–
Remove plug
–
Remove pressure spring
300347-10
–
Remove the oil pressure regulator valve. (
–
Measure the spring length of the oil pressure regulator valve.
Oil pressure regulator valve
Minimum length of pressure spring
»
If the measured value does not meet specifications:
–
Change the spring.
–
Install the oil pressure regulator valve. (
200155-10
–
Install ball
–
Mount and tighten plug
Guideline
Plug, oil pressure regulator valve
300347-11
–
Remove the crankshaft seal ring in clutch cover
300348-10
and shift shaft
.
M5
with sealing washer
.
and ball
.
and pressure spring
.
with sealing washer
in flush, with the open side
2 Nm
Loctite
®
(1.5 lbf ft)
p. 113)
23.5 mm (0.925 in)
p. 113)
.
M12x1.5
20 Nm
(14.8 lbf ft)
.
113
243™