01/FORK, TRIPLE CLAMP
Positioning the fork protection
5.7
Removing the fork legs
5.8
Installing the fork legs
5.9
–
Position the fork protection on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the brake line and cable harness. Put the clamp on, and mount and
tighten screws
–
Position the fork protection on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis
100381-11
–
Remove the front wheel. (
(FE EU, FE AUS)
–
Remove the headlight mask with the headlight. (
(FE USA)
–
Remove the start number plate. (
–
Remove screws
300713-10
–
Remove cable binders
–
Remove screws
–
Allow the brake caliper and brake line to hang tension-free to the side.
300714-10
–
Unscrew screws
–
Unscrew screws
300715-10
–
Position the fork legs.
Info
The upper milled groove in the fork leg must be flush with the top edge of
the upper triple clamp.
Position bleeder screws
300724-10
M6
.
M6
p. 65)
p. 63)
and take off the clamp.
.
and take off the brake caliper.
. Take out the left fork leg.
. Take out the right fork leg.
toward the front.
12
.
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
p. 88)