Table of Contents
Advertisement
01/FORK, TRIPLE CLAMP
Assembling the compression damping fitting
5.17
Info
The steps are identical for both fork legs.
–
Measure the run-out of the inner tube.
Inner tub run-out
»
If the measured value is larger than the specified value:
–
Replace the inner tube.
200685-10
–
Check the outer tube for damage.
»
If there is damage:
–
Replace the outer tube.
200632-10
–
Check the surface of the sliding bushing.
»
If the bronze-colored layer
–
Replace the sliding bushing.
200665-10
–
Check the spring length.
Guideline
Spring length with preload spacer(s)
»
If the measured value is greater than the specified value:
–
Reduce the thickness of the preload spacer.
»
If the measured value is smaller than the specified value:
–
Increase the thickness of the preload spacer.
200666-10
–
Clamp the compression damping fitting in a bench vise using soft jaws.
–
Mount O-ring
–
Grease the O-ring.
Lubricant (T158) (
200704-11
can be seen beneath the sliding layer
and seal ring
.
p. 265)
≤ 0.20 mm (≤ 0.0079 in)
510 mm (20.08 in)
20
:
Advertisement
Table of Contents
