11/Wiring Harness, Battery; Disconnecting The Negative Cable Of The Battery; Connecting The Negative Cable Of The Battery; Changing The Main Fuse - HUSABERG FE 450 EU Repair Manual

11/WIRING HARNESS, BATTERY

Disconnecting the negative cable of the battery

14.1

Connecting the negative cable of the battery

14.2

Changing the main fuse

14.3
Warning
Fire hazard The electrical system can be overloaded by the use of incorrect fuses.
–
Use only fuses with the prescribed amperage. Never by-pass or repair fuses.
Info
The main fuse protects all power consumers of the vehicle. It is located in the housing of the starter relay on the battery cover.
–
Switch off all power consumers and the engine.
–
Remove the seat. (
–
Disconnect negative cable
Info
Pay attention to the contact disks between the cable sockets and battery
terminals.
300675-10
–
Connect negative cable
Info
Contact disks
sockets
300675-10
–
Tighten the screw.
Guideline
Screw, battery terminal
100424-10
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. (
–
Detach connector
–
Remove protection covers
100426-10
p. 59)
of the battery.

.

must be mounted between battery terminals

with the claws facing up.

M5
p. 59)
.

.

73
and cable

3 Nm (2.2 lbf ft)