OPERATION INSTRUMENTS
CLUTCH LEVER
The clutch lever (1) is located on the left side of the handlebar. The adjust-
ing screw (A) is used to change the original position of the clutch lever
(see maintenance work on chassis and engine).
1
A
HAND DECOMPRESSION LEVER
The hand decompression lever (2) is needed only if the carburetor over-
flows after a fall. To "pump the engine free", pull the hand decompression
2
lever during the starting procedure.
The outer end of the lever must provide for a backlash of approx. 10 mm
(0.4 in) at all times. Only thereafter may it cause valve motion (to be recog-
nized by the stronger resistance which the hand decompression lever
encounters).
HAND BRAKE LEVER
The hand brake lever (3) is located on the right side of the handlebar and
actuates the front brake. The basic setting of the hand brake lever can
be adjusted (see maintenance work).
3
SHORT CIRCUIT BUTTON
The short circuit button (4) turns off the engine. When pressing this but-
ton, the ignition circuit is short-circuited.
4
- 6 -