WORK
Removing the headlight mask with the headlight
3.1
Installing the headlight mask with the headlight
3.2
Installing the front wheel
3.3
Warning
Danger of accidents Reduced braking due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
–
Switch off all power consumers and the engine.
–
Open rubber band
–
Tilt the headlight mask forward and detach it from nose
–
Disconnect connector
–
Pull bulb socket
mask.
100460-10
–
Connect plug
–
Insert bulb socket
–
Check that the lighting is working properly.
–
Attach headlight holder
100460-11
–
Wrap rubber band
The wiring harness and brake line
–
Check the headlight adjustment.
100461-10
–
Clean and grease shaft seal rings
Long-life grease (
–
Insert the spacing sleeves.
100412-11
–
Lift the front wheel into the fork, position it, and insert the wheel spindle.
–
Mount and tighten screw
Guideline
Screw, front wheel spindle
–
Operate the hand brake lever several times until the brake pads are lying correctly
on the brake disc.
–
Remove the motorcycle from the work stand.
100410-11
–
Pull the front wheel brake and push down hard on the fork several times to align
the fork legs.
on the fork legs.
.
out of the high beam indicator lamp and remove the headlight
.
into the high beam indicator lamp.
at the nose
and position the headlight mask.
around the fork legs and close it.
are routed in front of the headlight mask.
and bearing surface
p. 12)
.
.
of the spacing sleeves.
M24x1.5
45 Nm
(33.2 lbf ft)
5