FAULT CODE
Ignition coil - check the control line for a short circuit to plus (terminal 30)
–
Measure the voltage between the specified points.
Break Out Box DT Pin 18 – measuring point Ground(−)
Voltage
»
If the measured value does not correspond to the specified value:
–
Check the cable from connector DT pin 18 to pin 1 of the ignition coil for a short circuit to plus (terminal 30).
»
If the measured value corresponds to the specified value:
–
Check the next possible cause:
Ignition coil - control line has a short circuit to ignition plus (terminal 15) (
Ignition coil - control line has a short circuit to ignition plus (terminal 15)
Ignition coil - control line is open
Condition
Th e diagnostic tool is disconnected.
The EFI control unit is disconnected.
The breakout box is connected to the wiring harness.
The control line of the ignition coil is disconnected.
–
Connect battery plus with Break Out Box PIN 18.
Info
The connection must be protected with a 5A fuse.
600849-01
Condition
Th e diagnostic tool is disconnected.
The EFI control unit is disconnected.
The breakout box is connected to the wiring harness.
The control line of the ignition coil is disconnected.
Ignition coil - check the control line for a short circuit to ignition plus (terminal 15)
–
Measure the resistance between the specified points.
Break Out Box DT Pin 1 – Break Out Box DT Pin 18
Resistance
»
If the measured value does not correspond to the specified value:
–
Check the cable from connector DT pin 18 to pin 1 of the ignition coil for a
short circuit to ignition plus (terminal 15).
»
If the measured value corresponds to the specified value:
600849-01
–
Check the next possible cause:
Ignition coil - control line is open (
400607-11
< 0.1 V
p. 206)
∞ Ω
p. 206)
206