Table of Contents
Advertisement
14/LIGHTING SYSTEM, INSTRUMENTS
Checking the headlight adjustment (FE EU, FE AUS)
16.8
A
0 0 A
Adjusting the beam width of the headlight (FE EU, FE AUS)
16.9
Changing the headlight bulb (FE EU, FE AUS)
16.10
Note
Damage to reflector Reduced luminance.
–
Grease on the bulb will evaporate due to the heat and be deposited on the reflector. Clean the bulb and keep it free of grease
before mounting.
–
Wrap rubber band
The wiring harness and brake line
–
Check the headlight adjustment. (
100461-10
–
On a light-colored wall behind a horizontal area, make a mark as high as the center
of the headlight.
–
Make another mark a distance
Guideline
B
0 0 B
Distance
–
Stand the motorcycle at distance
beam.
Guideline
400558-10
Distance
–
Check the headlight adjustment.
The border between light and dark must be exactly at the lower mark when the
motorcycle is operational and complete with rider.
»
If the boundary between light and dark does not meet specifications:
–
Adjust the beam width of the headlight. (
–
Check the headlight adjustment. (
–
Adjust the beam width of the headlight by turning adjusting screw
Guideline
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with a rider (mark is applied under: Checking the headlight adjust-
ment).
Info
Turn clockwise to increase the beam width, turn counterclockwise to reduce
the beam width.
100459-10
If you have a payload, you may have to correct the headlight beam width.
–
Remove the headlight mask with the headlight. (
–
Turn rubber cap
the way and remove it.
–
Pull lamp socket
100462-10
around the fork legs and close it.
are routed in front of the headlight mask.
p. 89)
under the first mark.
5 cm (2 in)
in from of the wall and switch on the low
5 m (16 ft)
p. 89)
together with the underlying bulb socket counterclockwise all
of the parking light out of the reflector.
p. 89)
.
p. 88)
89
Advertisement
Table of Contents
