04/SHOCK ABSORBER, SWINGARM
Assembling the rebound adjuster
7.21
–
Press the heim joint against the lock ring using the special tool.
Pressing tool (T1207S) (
–
Mount the second lock ring
200801-10
–
Mount seal ring
200800-11
–
Position both collar bushings
200804-10
–
Grease O-ring
Lubricant (T158) (
–
Mount rebound needle
Info
Push in the rebound needle to the point where it is possible to mount the
rebound damping adjusting screw.
–
Mount rubber plug
200808-10
–
Lubricate spring, balls
Lubricant (T159) (
–
Screw in the rebound damping adjusting screw
–
Mount and tighten screwsleeve
Guideline
Screwsleeve
–
Screw out the rebound damping adjusting screw
200809-10
–
Grease the O-ring of the rebound damping seat.
Lubricant (T159) (
–
Mount and tighten rebound damping valve seat
Guideline
Rebound damping valve
seat
Info
200810-10
The rebound damping valve seat must be pressed inward before tightening.
p. 275)
.
on both sides.
and press in.
of the rebound needle.
p. 265)
in the piston rod.
.
and O-ring
.
p. 266)
.
M14x1
p. 266)
M8x1
all the way.
18 Nm
(13.3 lbf ft)
to the stop.
.
6 Nm
Loctite
®
2701
(4.4 lbf ft)
42