Installing The Oil Pumps; Installing The Oil Pump Gears; Installing The Starter Idler Gear - HUSABERG FE 450 EU Repair Manual

30/ENGINE ASSEMBLY

Installing the oil pumps

20.11

Installing the oil pump gears

20.12

Installing the starter idler gear

20.13
–
Oil the oil pump shaft, internal rotor and external rotor before assembly.
Engine oil (SAE 10W/50) (
–
Assemble both oil pump shafts
The marking of force pump
pump

–
Mount both external rotors
The markings are not visible after assembly.
300335-11
–
Position oil pump cover
Guideline
Screw, oil pump cover
300334-11
–
Insert pin

300333-11
–
Position oil pump gears
Info
Ensure that the pins are seated properly.
–
Position washers
–
Mount shaft locking devices
–
Crank the oil pump gears and ensure that they move easily.
300332-11
–
Slide on starter idler gear
–
Slide on the disk. Mount the lock ring.
300331-10
p. 263)
, together with the pin and internal rotor

is visible after assembly, that of suction

is not.
.

. Mount and tighten screws

M5
.
.

.

.

with the collar facing the engine case.


.

6 Nm Loctite ® 222
(4.4 lbf ft)
140
.