Test Sequence Errors - Quantum Data 881 User Manual

3011
3015
3020
3025
3050

4000-4999 Test sequence errors

4000
4001
4002
4003
4004
674 Appendix C Error Messages
R, G or B 6-Bit video DAC setting out of range
A combination of system calibration factors, user calibration multiplier settings and video
output level settings have resulted in one or more calculated input values to go below zero
or above the analog video Digital-to-Analog Converter's maximum limit of 63.
R, G or B 10-Bit video DAC setting out of range
A combination of system calibration factors, user calibration multiplier settings and video
output level settings have resulted in one or more calculated input values to go below zero
or above the analog video Digital-to-Analog Converter's maximum limit of 1023.
Kill EPROM image
Built in test images can not be removed from the firmware.
Image not found
A test image of a given name could not be found as either a built-in test image in the
firmware or as a user defined custom image.
Grayscale video DAC setting out of range
One or more internal calculations have resulted in an analog video DAC input grayscale
setting below zero or greater than 100% video level.
Invalid format name
The test sequence contains one or more steps that have an invalid format name
parameter.
Invalid image name
The test sequence contains one or more steps that have an invalid image name
parameter.
No sequence memory
There is not enough unused edit buffer memory space available to start a new test
sequence editing session.
Sequence memory full
There is not enough free battery backed user storage memory to save the sequence that
is in the edit buffer.
Sequence not found
A test sequence of the given name could not be found in the user storage memory area.