Quantum Data 881 User Manual page 1102

2124
2125
2126
2128
2129
2130
2140
2141
2150
2151
2152
2155
664 Appendix C Error Messages
Send GEN info error is not zero
The General infoframe register on the transmitter is not set to zero and the infoframe is not
transmitted. This typically means that there is a hardware problem in the HDMI board.
Invalid sonic data
The value specified for the digital audio mixer (SDMG) is out of range.
Invalid content aspect ratio
The value specified by the CXAR (content aspect ratio) parameter is invalid.
Invalid audio contents
Invalid signal aspect ratio
The value specified by the SXAR (signal aspect ratio) parameter is invalid.
Horizontal active too small
The number of active pixels per horizontal scan line is less than the minimum supported
by the generator hardware configuration.
Horizontal blanking too small
The video format's horizontal blanking period expressed in microseconds and/or number
of pixel clock cycles is not supported by the generator hardware configuration.
Horizontal blanking too small
Same as Error number 2140. Found in some firmware releases for different generator
hardware configurations.
Horizontal blanking too small
Same as Error number 2140. Found in some firmware releases for different generator
hardware configurations.
Horizontal total less than horizontal resolution
The video format's total (active + blanked) number of pixel clock cycles per horizontal scan
line can not be less than the number of active pixels per scan line.
Horizontal resolution too large or Horizontal blanking too small
Same as Error number 2140. Found in some firmware releases for different generator
hardware configurations.
Horizontal blanking too small
Same as Error number 2140. Found in some firmware releases for different generator
hardware configurations.