Siemens SIMATIC FM 353 Manual page 80

Defining Parameters
Loading the SDB in the CPU
When you have created the SDB, you must load the "system data" of the project
into the CPU.
There are two ways of proceeding:
Method 1
Select the online window in the SIMATIC Manager (the online and offline win-
dows must be open)
Copy the system data from the offline project in CPU\S7-Program\Blocks\Sys-
tem data into the online project (drag with the mouse or select Copy/Paste).
Method 2
Select the system data in the SIMATIC Manager in CPU\S7-Pro-
gram\Blocks\System data.
Activate the menu Target system > Load (or the right mouse button) to load
the system data into the CPU
or
Use the menu Target system > Load in EPROM memory card on CPU
You can also program the memory card for the CPU on a programming device/PC.
If the configuration is loaded from HW-CONFIG, this SDB is not loaded into the
CPU.
Deleting SDBs in the CPU
To delete the SDBs in the CPU:
1. Select "Parameterize FM 353".
2. Select menu File > Display SDB. Delete the SDB(s).
3. Close "Parameterize FM 353" and in the SIMATIC Manager in Online Project
select CPU\S7-Progam\Blocks\System data. Delete the system data.
4. Transfer the system data to the CPU again (see above)
5-28
FM 353 Stepper Drive Positioning Module
6ES7 353-1AH01-8BG0
J