Siemens SIMATIC FM 353 Manual page 334

Troubleshooting
Table 11-8 General data errors, machine data errors, traversing program errors, continued
Cl. No.
Traversing program errors
8 (08) 30 (1E) Error, subroutine
Cause
Effect
Elimination
8 (08) 31 (1F) Velocity missing
Cause
Effect
Elimination
8 (08) 32 (20) Error, callup subroutine
Cause
Effect
Elimination
8 (08) 33 (21) D function unacceptable
Cause
Effect
Elimination
8 (08) 34 (22) Incorrect program length
Cause
Effect
Elimination
Cl. = Detail event class, No. = Detail event number, CBS = checkback signals, DB = data block
Note: Value (xx) = Hexadecimal notation of the error number
11-32
Error message,
error analysis and remedy
Error response: "Warning" see Table 11-2
Subroutine without number of runs
Program is not stored
Correct program, per cause
No velocity was programmed
Program/block not stored
Correct program, per cause
Block syntax for callup subroutine is incorrect
Program is not stored
Correct program, per cause
Block syntax for invoking a D function is incorrect
Program is not stored
Correct program, per cause
Maximum block number exceeded
Program is not stored
Correct program, per cause
FM 353 Stepper Drive Positioning Module
6ES7 353-1AH01-8BG0
Mes-
sage/
Display
CBS
or
DB DB
CBS
or
DB DB
CBS
or
DB DB
CBS
or
DB DB
CBS
or
DB DB
J