Siemens SIMATIC FM 353 Manual page 326

Troubleshooting
Table 11-8 General data errors, machine data errors, traversing program errors, continued
Cl. No.
General data errors
4 (04) 123 (7B) NC program number already exists
Cause
Effect
Elimination
4 (04) 124 (7C) Parameter "Protect" incorrect
Cause
Effect
Elimination
4 (04) 125 (7D) DB memory filed
Cause
Effect
Elimination
4 (04) 126 (7E) Allowable program length exceeded
Cause
Effect
Elimination
4 (04) 127 (7F) Writing parameters/data is not possible
Cause
Effect
Elimination
4 (04) 128 (80) Incorrect module identification
Cause
Effect
Elimination
4 (04) 129 (81) Incremental value, incorrect value
Cause
Effect
Elimination
Cl. = Detail event class, No. = Detail event number, CBS = checkback signals, DB = data block
Note: Value (xx) = Hexadecimal notation of the error number
11-24
Error message,
error analysis and remedy
Error response: "Warning" see Table 11-2
NC program number already exists
DB does not become effective and is stored non-retentively
Prior to transmission, delete corresponding DB with the pro-
gram number
Coding not 0 or 1
DB does not become effective and is stored non-retentively
Coding not 0 or 1
The available memory is assigned
DB does not become effective and is stored non-retentively
Delete unnecessary programs (DBs) or compress memory
by way of parameterization interface
Number of blocks too high
DB does not become effective and is stored non-retentively
Correct program and retransmit
Axis does not come to a stop
Parameters/data do not become effective
Stop axis
DBs which do not belong to the module were transmitted
(no identification 353)
DB does not become effective and is not stored modally
Transmit the DBs belonging to the FM 353
Value range outside "10
Incremental value not effective
Transmit correct value
9
FM 353 Stepper Drive Positioning Module
Mes-
sage/
Display
CBS
or
DB DB
CBS
or
DB DB
CBS
or
DB DB
CBS
or
DB DB
CBS
or
DB DB
CBS
or
DB
CBS
or
DB DB
6ES7 353-1AH01-8BG0