Wiring - Siemens SIMATIC FM 353 Manual

Wiring

Chapter Overview
Section
4.1
4.2
4.3
4.4
4.5
Safety rules
In order to ensure the safe operation of your plant, you should introduce the follow-
ing additional measures, and adjust them appropriately to your system's condi-
tions:
S An EMERGENCY STOP concept meeting appropriate safety regulations (e.g.
European standards EN 60204, EN 418 and associated standards).
S Additional measures for limiting the end position of axes
(e.g. hardware limit switches).
S Equipment and measures for protecting the motors and power electronics in
accordance with the installation guidelines for FM STEPDRIVE/SIMOSTEP.
We also recommend you carry out a risk analysis in accordance with basic safety
requirements / Appendix 1 of the EC machine directive, in order to identify sources
of danger affecting the complete system.
Further references
Please refer also to the following chapters in the manual S7-300 Programmable
Controller, Hardware and Installation:
S Lightning protection and overvoltage protection: Chapter 4.2
S Guidelines for handling of electrostatic sensitive devices (ESDs): Appendix B.
S Configuring the electrical installation: Chapter 4.
For further information about EMC guidelines, we recommend the description in:
Equipment for Machine Tools, EMC guidelines for WS/WF equipment, Order No.:
6ZB5 440-0QX01-0BA1.
FM 353 Stepper Drive Positioning Module
6ES7 353-1AH01-8BG0
Wiring an FM 353
Description of the drive interface
Connecting the drive unit
Description of the I/O interface
Wiring up the front connector
Section Header
4
Page
4-2
4-4
4-11
4-12
4-18
4-1