Siemens SIMATIC FM 353 Manual page 320

Troubleshooting
Table 11-7 Travel errors, continued
Cl. No.
Travel errors
3 (03) 30 (1E) Digital input not parameterized
Cause
Effect
Elimination
3 (03) 35 (23) Tool offset value not in place
Cause
Effect
Elimination
3 (03) 36 (24) Set actual value on the fly, incorrect value
Cause
Effect
Elimination
3 (03) 37 (25) MDI block on the fly, incorrect syntax
Cause
Effect
Elimination
3 (03) 38 (26) MDI block on the fly, incorrect velocity
Cause
Effect
Elimination
Cl. = Detail event class, No. = Detail event number, CBS = checkback signals, DB = data block
Note: Value (xx) = Hexadecimal notation of the error number
11-18
Error message,
error analysis and remedy
Error response: "Feed STOP" see Table 11-2
For the following functions, no necessary digital input is para-
meterized:
S
Set travel with actual value on the fly (G88, G89)
S
External block change (G50)
S
Measurement
S
Rotation monitoring
Functions are not started.
Parameterization of the digital inputs by way of MD34 or
MD37
No tool offset values are available on the FM 353 or tool off-
sets are accessed and modified when an override is active.
Parameterize and read in tool offset values
Value is no longer within the range"10
Input a correct value
Incorrect M or G commands or incorrect block structure
Input a correct MDI block
Velocity not within the range between > 0 and max. allowable
traverse velocity (500 000 000 MSR/min)
Input a correct MDI block
9
FM 353 Stepper Drive Positioning Module
6ES7 353-1AH01-8BG0
Mes-
sage/
Display
CBS
CBS
CBS
CBS
CBS