Siemens SIMATIC FM 353 Manual page 314

Troubleshooting
Table 11-5 Operating errors, continued
Cl. No.
Operating errors
1 (01) 2 (02) Software limit switches, end is passed
Cause
Effect
Elimination
1 (01) 3 (03) Beginning of traversing range passed
Cause
Effect
Elimination
1 (01) 4 (04) Traversing range end passed
Cause
Effect
Elimination
1 (01) 90 − 99 System errors
(5A (5A − 63) 63)
Cause
Effect
Elimination
Cl. = Detail event class, No. = Detail event number
Note: Value (xx) = Hexadecimal notation of the error number
11-12
Error message,
error analysis and remedy
Error response: "Everything Off", as in Table 11-2
Limit switch passed: in "Control" operating mode
S
The limit switch position is passed by the necessary stop-
ping distance.
S
Set actual value is not executed.
S
Following acknowledgment of the error, it is possible to
traverse to the working range.
S
Alter value of software limit switch (MD22)
S
Switch off monitoring limit switch occasionally!
(With the limit switches (MD21/22) disabled, the
!
travel range limits are established by the
maximum allowable values for the limit switches).
When operating in "Control" operating mode with soft limits
disabled, the traversing range beginning was passed.
The limit switch position is passed by the necessary stopping
distance.
Following acknowledgment of the error, it is possible to tra-
verse to the working range.
When operating in "Control" operating mode with soft limits
disabled, the traversing range beginning was passed.
The limit switch position is passed by the necessary stopping
distance.
Following acknowledgment of the error, it is possible to tra-
verse to the working range.
Internal errors in the module
Undefined effects possible
If this manual is observed, the errors should not occur
However, should this still be the case, please consult the
responsible sales department. When doing so, it is vitally
important to also report the exact circumstances leading to
the error.
FM 353 Stepper Drive Positioning Module
6ES7 353-1AH01-8BG0
Mes-
sage/
Dis-
play
Diag-
nostic ti
inter- inter-
rupt
Diag-
nostic ti
inter-
rupt rupt
Diag-
nostic ti
inter-
rupt rupt
Diag-
nostic ti
inter- inter-
rupt
LED
"DIAG"
blinking