SMC Networks PSE200 Operation Manual page 26

○Auto-shift function
This function corrects the setting value of each switch output according to change of pressure source. Even if pressure
source is changed, this can do correct decision on switch output.
Refer to below or page 26 for detail.
•Press the
or
[on]/[oF] will flicker alternately. Press the
makes it move to the automatic identification function.
•Selection of auto-shift mode by press the
•Similarly, [CH2], [CH3] and [CH4] press the
•After auto-shift mode setting of all channels is completed, if press the
automatic identification function.
○About auto-shift function
This function corrects the setting value of each switch output according to change of pressure source.
Even if pressure source is changed, this can do correct decision on switch output.
•Correction of setting value by auto-shift use
•Using with auto-shift input, accepted setting range is like below
button in the state where [SH1] is displayed, and [CH1] and
button with the indication of [SH1]
or button, and press the
or button, and selection of auto-shift mode.
-25-
button.
button, it will move to
No.PS##-OMH0006-C