Replacing The Bottom Enclosure - Respironics DreamStation Service & Technical Reference Manual

1117539, V . 07
ER
6.1.11 R
EPLACING THE
Kit
Bottom Enclosure
Warning Label
T B
O REMOVE THE OTTOM
1. Remove all components as instructed in the previous sections (it is not required to remove the
Blower Upper Cap, Blower or Blower Isolators – these can be left assembled and lifted from the
Bottom Enclosure as one assembly if they do not require replacement).
T B
O INSTALL THE OTTOM
1. Place a new warning label and Serial/Model Number label on the bottom of the Bottom Enclosure
(refer to Figure 6-31 for label placement and refer to Section 6.2 for Serial/Model Number label
creation).
2. Assemble the remainder of the device as instructed in the previous sections.
F
IGURE
B E
OTTOM NCLOSURE
•
Bottom Enclosure
•
Warning Label
E :
NCLOSURE
E :
NCLOSURE
6-35: W L
ARNING ABEL AND
Included in Kit
S /M N
ERIAL ODEL UMBER
Tools Required
•
Torx Screwdriver (T10 is
recommended).
L P
ABEL LACEMENT
P 6-25
AGE