Respironics DreamStation Service & Technical Reference Manual page 97

P 6-24
AGE
6.1.10 R
EPLACING THE
Kit
DC Power Cable
DC Jack Color Insert
T DC P
O REMOVE THE
1. Remove all components as instructed in the previous sections.
Note: It is not required to remove the Blower Upper Cap, Blower or Blower Isolators – these can be left
assembled and lifted from the Bottom Enclosure as one assembly.
2. Turn the Bottom Enclosure Over.
3. Push downward on the DC Jack Color Insert.
F 6-33: B
IGURE
T DC P
O INSTALL THE
1. Align the DC Jack Color Insert and DC Cable into the grooves as shown in the Figure below.
2. Assemble the remainder of the device as instructed in the previous sections.
DC P C
OWER ABLE AND
•
DC Power Cable
•
DC Jack Color Insert
C DC J
OWER ABLE AND
E
OTTOM NCLOSURE
C DC J
OWER ABLE AND
F 6-34: DC C
IGURE
DC J C
ACK OLOR
Included in Kit
C I :
ACK OLOR NSERT
F R
LIPPED TO EMOVE
C I :
ACK OLOR NSERT
Ensure black tab from either
side of cable is facing upward
and label is facing inward
C J
ABLE AND OLOR ACK
I
NSERT
Tools Required
•
Torx Screwdriver (T10 is
recommended).
Push DC Jack
Color Insert
downward
C I /DC C
OLOR NSERT ABLE
I
NSERT
1117539, V . 07
ER