Replacing The Blower Upper Cap - Respironics DreamStation Service & Technical Reference Manual

P 6-12
AGE
6.1.7 R
EPLACING THE
Kit
Blower Upper Cap
T B
O REMOVE THE LOWER
1. Remove all components as instructed in the previous sections
2. Remove the four # 4 x 1/2" screws holding the Blower Cap to the Blower Box Assembly.
3. Using a small flathead screwdriver, carefully pry the Blower Cap off of the Blower Box Assembly
around the Blower Cap chimney as to not damage the Blower Cap seal.
Damage can occur to the seal on the underside of the Blower Upper Cap
if prying in the wrong spots. Be sure to pry the Cap off only at the
Chimney (refer to the Figure below).
B U C
LOWER PPER AP
Included in Kit
•
Blower Upper Cap
•
# 4 x 1/2" screws (qty 4)
U C
:
PPER AP
CAUTION
Torque screws to 2.5 IN-LB
when installing Blower Cap.
Pry off Blower Cap around
Chimney edge
F 6-12: B
IGURE LOWER
•
Torx Screwdriver (T10 is
recommended)
•
Flathead Screwdriver
Blower Cap Chimney
U C R
PPER AP EMOVAL
1117539, V
Tools Required
. 07
ER