Respironics DreamStation Service & Technical Reference Manual page 89

P 6-16
AGE
8. Pull the wire grommet out of the Blower Box Assembly groove.
F
9. Carefully lift the Blower straight out of the Blower Box Assembly.
10. Lift the Blower Assembly out of the Blower Box.
T B
O INSTALL THE LOWER
1. Position the Blower inside the Blower Box Assembly so that the Blower Outlet Seal and Blower
Isolators are aligned in their grooves (refer to the Figure below).
•
The SK and Moog Blowers are not interchangeable. Ensure to replace SK with SK, and
Moog with Moog.
•
The Blower with the Isolators attached should be rested inside the Blower Box. Do not
press down on the Blower after installation.
Push Ferrite down
6-17: B B
IGURE LOWER
, B B A
LOWER OX SSEMBLY AND
Blower Outlet Seal
F 6-18: S
IGURE
F B
OX ERRITE AND LOWER
R P
EAR ANEL
CAUTION
Blower Isolators
B
EATING OF LOWER
1117539, V
Grommet
W G
IRE ROMMET
:
. 07
ER