Respironics DreamStation Service & Technical Reference Manual page 118

1117539, V . 07
ER
7.1.10 R
EPLACING THE
Included in Kit
Heater Plate O-Ring
T H
O REMOVE THE EATER
1. Remove the Bottom Cover as instructed in section 7.1.8.
2. Lift up the Heater Plate.
3. Pull the O-Ring from the Bottom Assembly.
T H
O INSTALL THE EATER
1. Place the O-Ring into the groove on the Bottom Assembly as shown in the Figure above.
2. Place the Heater Plate back into position.
3. Install the Bottom Cover as instructed in section 7.1.8.
N
: Ensure the Heater Plate is seated properly and the wires are routed as shown in the Figure below
OTE
before installing the Bottom Cover. Also ensure the wires aren't pinched when installing the Bottom Cover.
H P O-R
EATER LATE
Included in Kit
•
Heater Plate O-Ring
F 7-22: H
IGURE
P O-R :
LATE ING
P O-R :
LATE ING
F 7-23: H
IGURE
ING
Heater Plate O-Ring
P O-R
EATER LATE ING
Route wires as shown
P I
EATER LATE NSTALLED
Tools Required
•
Torx Screwdriver (T15 is
recommended)
P 7-15
AGE