Sample Configuration - Dell S4048T Configuration Manual

seq 40 redirect 43.1.1.2 tcp 155.55.2.0/24 222.22.2.0/24, Next-hop reachable
(via Vl 30)
seq 45 redirect 31.1.1.2 track 200 ip 12.0.0.0 255.0.0.197 13.0.0.0
255.0.0.197, Track 200 [up], Next-hop reachable (via Te 1/32)
, Track 200 [up], Next-hop reachable (via Vl 20)
, Track 200 [up], Next-hop reachable (via Po 5)
, Track 200 [up], Next-hop reachable (via Po 7)
, Track 200 [up], Next-hop reachable (via Te 2/18)
, Track 200 [up], Next-hop reachable (via Te 2/19)
Use the show ip redirect-list (without the list name) to display all the redirect-lists configured on
the device.
Dell#show ip redirect-list
IP redirect-list rcl0:
Defined as:
seq 5 permit ip 200.200.200.200 200.200.200.200 199.199.199.199
199.199.199.199
seq 10 redirect 1.1.1.2 tcp 234.224.234.234 255.234.234.234
222.222.222.222/24 eq 40 ack, Next-hop reachable
(via Te 2/1),
Applied interfaces:
Te 2/2
NOTE: If you apply the redirect-list to an interface, the output of the show ip redirect-list
redirect-list-name command displays reachability status for the specified next-hop.
Example: Showing CAM PBR Configuration
Dell#show cam pbr stack-unit 1 port-set 0
TCP Flag: Bit 5 - URG, Bit 4 - ACK, Bit 3 - PSH, Bit 2 - RST, Bit 1 - SYN, Bit
0 - FIN
Cam Port VlanID Proto Tcp
Egress
Index Flag Port
-------------------------------------------------------------------------------
----------------------------------
06080 0 N/A
199.199.199.199 N/A
06081 0 N/A
222.222.222.222/24

Sample Configuration

You can use the following example configuration to set up a PBR. These are not comprehensive directions
but are intended to give you a guidance with typical configurations. You can copy and paste from these
Src
Port MAC Port
IP 0x0 0 0 200.200.200.200 200.200.200.200 199.199.199.199
NA
TCP 0x10 0 40 234.234.234.234 255.234.234.234
00:00:00:00:00:09 8/1
Dst SrcIp DstIp
Policy-based Routing (PBR)
Next-hop
774