Udp Helper With Broadcast-All Addresses - Dell S4048T Configuration Manual

UDP Helper with Broadcast-All
Addresses
When the destination IP address of an incoming packet is the IP broadcast address, Dell Networking OS
rewrites the address to match the configured broadcast address.
In the following illustration:
1 Packet 1 is dropped at ingress if you did not configure UDP helper address.
2 If you enable UDP helper (using the ip udp-helper udp-port command), and the UDP destination
port of the packet matches the UDP port configured, the system changes the destination address to the
configured broadcast 1.1.255.255 and routes the packet to VLANs 100 and 101. If you do not configure
an IP broadcast address (using the ip udp-broadcast-address command) on VLANs 100 or 101, the
packet is forwarded using the original destination IP address 255.255.255.255.
Packet 2, sent from a host on VLAN 101 has a broadcast MAC address and IP address. In this case:
1 It is flooded on VLAN 101 without changing the destination address because the forwarding process is
Layer 2.
2 If you enabled UDP helper, the system changes the destination IP address to the configured broadcast
address 1.1.255.255 and forwards the packet to VLAN 100.
3 Packet 2 is also forwarded to the ingress interface with an unchanged destination address because it
does not have broadcast address configured.
Figure 55. UDP Helper with Broadcast-All Addresses
IPv4 Routing 514