Troubleshooting Frrp; Configuration Checks; Sample Configuration And Topology - Dell S6100 Configuration Manual

• Show the information for the identified FRRP group.
EXEC or EXEC PRIVELEGED mode.
show frrp ring-id
Ring ID: the range is from 1 to 255.
• Show the state of all FRRP groups.
EXEC or EXEC PRIVELEGED mode.
show frrp summary
Ring ID: the range is from 1 to 255.

Troubleshooting FRRP

To troubleshoot FRRP, use the following information.

Configuration Checks

• Each Control Ring must use a unique VLAN ID.
• Only two interfaces on a switch can be Members of the same control VLAN.
• There can be only one Master node for any FRRP group.
• You can configure FRRP on Layer 2 interfaces only.
• Spanning Tree (if you enable it globally) must be disabled on both Primary and Secondary interfaces when you enable FRRP.
• When the interface ceases to be a part of any FRRP process, if you enable Spanning Tree globally, also enable it explicitly for the
interface.
• The maximum number of rings allowed on a chassis is 255.

Sample Configuration and Topology

The following example shows a basic FRRP topology.
Example of R1 MASTER
interface TenGigabitEthernet 1/1/1/1
no ip address
switchport
no shutdown
!
interface TenGigabitEthernet 1/1/1/2
no ip address
switchport
no shutdown
!
interface Vlan 101
no ip address
tagged TenGigabitEthernet 1/1/1/2,1/1/1/2
no shutdown
!
interface Vlan 201
no ip address
tagged TenGigabitEthernet 1/1/1/1, 1/1/1/2
no shutdown
!
protocol frrp 101
interface primary TenGigabitEthernet 1/1/1/1
secondary TenGigabitEthernet 1/1/1/2 control-vlan 101
member-vlan 201
330 Force10 Resilient Ring Protocol (FRRP)