Microsoft Network Load Balancing; Nlb Unicast Mode Scenario - Dell S4048T Configuration Manual

Microsoft Network Load Balancing

Network load balancing (NLB) is a clustering functionality that is implemented by Microsoft on Windows 2000
Server and Windows Server 2003 operating systems (OSs). NLB uses a distributed methodology or pattern to
equally split and balance the network traffic load across a set of servers that are part of the cluster or group.
NLB combines the servers into a single multicast group and attempts to use the standard multicast IP or
unicast IP addresses and MAC addresses to transmit of network traffic. At the same time, NLB also uses a
single virtual IP address for all clients as the destination IP address, which enables servers to join the same
multicast group that is transparent to the clients (the clients do not notice the addition of new servers to the
group). The clients use a cluster IP address to connect to the server. To avoid overloading and effective
performance of the servers for optimal processing of data packets, NLB enables flooding of traffic over the
virtual local area network (VLAN) ports (for Unicast mode) or a subset of ports in a VLAN (for Multicast mode.)
NLB functions in two modes, Unicast mode and Multicast mode. Configure the cluster IP address and the
associated cluster MAC address in the NLB application running on the Windows Server.
• In Unicast mode, when the server IP address attempts to be resolved to the MAC address using the
address resolution protocol (ARP), the switch determines whether the ARP reply, obtained from the
server, is an NLB type. The switch then maps the IP address (cluster IP) with the MAC address (cluster
MAC address).
• In Multicast mode, the cluster IP address maps to a cluster multicast MAC address you configured using
a static ARP command. After the NLB entry is learned, the traffic forwards to all the servers in the
VLAN corresponding to the cluster virtual IP address.

NLB Unicast Mode Scenario

Consider a topology in which you configure four servers, S1 through S4, as a cluster or a farm. This set of
servers connects to a Layer 3 switch, which connects to the end-clients. The servers contain a single IP
address (IP-cluster address of 172.16.2.20) and a single unicast MAC address (MAC-Cluster address of 00-bf-
ac-10-00-01) for load-balancing. Because multiple ports on a switch cannot learn a single MAC address, the
servers are assigned MAC addresseses of MAC-s1 to MAC-s4), respectively, on S1 through S4 in addition to
the MAC cluster address. All the servers of the cluster belong to VLAN1.
In Unicast NLB mode, the following sequence of events occurs:
• The switch sends an ARP request to resolve the IP address to the cluster MAC address.
• The ARP servers send an ARP response with the MAC cluster address in the ARP header and a MAC
address of MAC-s1/s2/s3/s4 (for servers S1 through S4) in the Ethernet header.
• The switch associates the IP address with the MAC cluster address with the last ARP response it obtains.
Assume that the last ARP reply is obtained from MAC-s4 (assuming that the ARP response with MAC-s4
is received as the last one). The interface associated with server, S4, is added to the ARP table.
• With NLB enabled, after learning the NLB ARP entry, all the subsequent traffic floods on all ports in
VLAN1.
To perform load-balancing, NLB, forwards the data frame to all the servers.
Microsoft Network Load Balancing
31
637