Important Points To Remember; Rstp And Vlt; Configuring Interfaces For Layer 2 Mode - Dell S4048T Configuration Manual

On system
Table of Contents

Advertisement

Enabling SNMP Traps for Root Elections and Topology Changes
Configuring Fast Hellos for Link State Detection
Flush MAC Addresses after a Topology Change

Important Points to Remember

RSTP is disabled by default.
Dell Networking OS supports only one Rapid Spanning Tree (RST) instance.
All interfaces in virtual local area networks (VLANs) and all enabled interfaces in Layer 2 mode are
automatically added to the RST topology.
Adding a group of ports to a range of VLANs sends multiple messages to the rapid spanning tree
protocol (RSTP) task, avoid using the range command. When using the range command, Dell
Networking recommends limiting the range to five ports and 40 VLANs.

RSTP and VLT

Virtual link trunking (VLT) provides loop-free redundant topologies and does not require RSTP.
RSTP can cause temporary port state blocking and may cause topology changes after link or node failures.
Spanning tree topology changes are distributed to the entire Layer 2 network, which can cause a network-
wide flush of learned media access control (MAC) and address resolution protocol (ARP) addresses, requiring
these addresses to be re-learned. However, enabling RSTP can detect potential loops caused by non-system
issues such as cabling errors or incorrect configurations. RSTP is useful for potential loop detection but to
minimize possible topology changes after link or node failure, configure it using the following specifications.
The following recommendations help you avoid these issues and the associated traffic loss caused by using
RSTP when you enable VLT on both VLT peers:
Configure any ports at the edge of the spanning tree's operating domain as edge ports, which are
directly connected to end stations or server racks. Ports connected directly to Layer 3-only routers not
running STP should have RSTP disabled or be configured as edge ports.
Ensure that the primary VLT node is the root bridge and the secondary VLT peer node has the second-
best bridge ID in the network. If the primary VLT peer node fails, the secondary VLT peer node becomes
the root bridge, avoiding problems with spanning tree port state changes that occur when a VLT node
fails or recovers.
Even with this configuration, if the node has non-VLT ports using RSTP that are not configured as edge
ports and are connected to other layer 2 switches, spanning tree topology changes can still be detected
after VLT node recovery. To avoid this scenario, ensure that you configure any non-VLT ports as edge
ports or have RSTP disabled.

Configuring Interfaces for Layer 2 Mode

To configure and enable interfaces in Layer 2 mode, use the following commands.
All interfaces on all bridges that participate in Rapid Spanning Tree must be in Layer 2 and enabled.
1
If the interface has been assigned an IP address, remove it.
INTERFACE mode
Rapid Spanning Tree Protocol (RSTP)
893

Advertisement

Table of Contents
loading

Table of Contents