Dell S4048T Configuration Manual page 1218

invalid because it not a multiple of 1 second. If you are using VRRP version 3, you must configure the timer
values in multiples of 25 centisecs.
If you are configured for VRRP version 2, the timer values must be in multiples of whole seconds. For
example, timer value of 3 seconds or 300 centisecs are valid and equivalent. However, a timer value of 50
centisecs is invalid because it not is not multiple of 1 second.
If are using VRRP version 3, you must configure the timer values in multiples of 25 centisecs.
To change the advertisement interval in seconds or centisecs, use the following command. A centisecs is
1/100 of a second.
• Change the advertisement interval setting.
INTERFACE-VRID mode
advertise-interval seconds
The range is from 1 to 255 seconds.
The default is 1 second.
• For VRRPv3, change the advertisement centisecs interval setting.
INTERFACE-VRID mode
advertise-interval centisecs centisecs
The range is from 25 to 4075 centisecs in units of 25 centisecs.
The default is 100 centisecs.
Examples of the advertise-interval Command
The following example shows how to change the advertise interval using the advertise-interval
command.
Dell(conf-if-te-1/1)#vrrp-group 111
Dell(conf-if-te-1/1-vrid-111)#advertise-interval 10
Dell(conf-if-te-1/1-vrid-111)#
The following example shows how to verify the advertise interval change using the show conf command.
Dell(conf-if-te-1/1-vrid-111)#show conf
!
vrrp-group 111
advertise-interval 10
authentication-type simple 7 387a7f2df5969da4
no preempt
priority 255
virtual-address 10.10.10.1
virtual-address 10.10.10.2
virtual-address 10.10.10.3
virtual-address 10.10.10.10
Virtual Router Redundancy Protocol (VRRP) 1218