Configuring Ipv6 Ra Guard On An Interface; Monitoring Ipv6 Ra Guard - Dell S4048T Configuration Manual

Configuring IPv6 RA Guard on an Interface

To configure the IPv6 Router Advertisement (RA) guard on an interface, perform the following steps:
1 Configure the terminal to enter the Interface mode.
CONFIGURATION mode
interface interface-type slot/port
2 Apply the IPv6 RA guard to a specific interface.
INTERFACE mode
ipv6 nd ra-guard attach policy policy-name [vlan [vlan 1, vland 2, vlan
3.....]]
3 Display the configurations applied on all the RA guard policies or a specific RA guard policy.
EXEC Privilege mode
show ipv6 nd ra-guard policy policy-name
The policy name string can be up to 140 characters.
Example of the show ipv6 nd ra-guard policy Command
Dell#show ipv6 nd ra-guard policy test
ipv6 nd ra-guard policy test
device-role router
hop-limit maximum
match ra ipv6-access-list
other-config-flag on
router-preference maximum medium
trusted-port
Interfaces :
Te 1/1
Dell#

Monitoring IPv6 RA Guard

To debug IPv6 RA guard, use the following command.
EXEC Privilege mode
debug ipv6 nd ra-guard [interface slot/port[/subport] | count value]
The count range is from 1 to 65534. The default is infinity.
For a complete listing of all commands related to IPv6 RA Guard, see the Dell Networking OS Command
Line Reference Guide.
1
access
IPv6 Routing 541