Designating A Multicast Router Interface - Dell S4048T Configuration Manual

ARP learn enable
• When ARP learn enable is enabled, the switch learns ARP entries for ARP Request packets even if the
packet is not destined to an IP configured in the box.
• The ARP learn enable feature is not applicable to the EIS routing table. It is applicable to the default
routing table only to avoid unnecessary double ARP entries
Sflow
sFlow management application is supported only in standalone boxes and switch shall throw error message if
sFlow is configured in stacking environment
Designating a Multicast Router
Interface
To designate an interface as a multicast router interface, use the following command.
Dell Networking OS also has the capability of listening in on the incoming IGMP general queries and
designate those interfaces as the multicast router interface when the frames have a non-zero IP source
address. All IGMP control packets and IP multicast data traffic originating from receivers is forwarded to
multicast router interfaces.
• Designate an interface as a multicast router interface.
ip igmp snooping mrouter interface
Internet Group Management Protocol (IGMP) 450