Table of Contents
Advertisement
Configuring a VLT VLAN Peer-Down (Optional)
To configure a VLT VLAN peer-down, use the following commands.
1
Enter VLT-domain configuration mode for a specified VLT domain.
CONFIGURATION mode
vlt domain domain-id
The range of domain IDs is from 1 to 1000.
2
Enter the port-channel number that acts as the interconnect trunk.
VLT DOMAIN CONFIGURATION mode
peer-link port-channel id-number
3
Enter the VLAN ID number of the VLAN where the VLT forwards packets received on the VLTi from an
adjacent peer that is down.
VLT DOMAIN CONFIGURATION mode
peer-down-vlan vlan interface number
Configuring Enhanced VLT (eVLT) (Optional)
To configure enhanced VLT (eVLT) between two VLT domains on your network, use the following procedure.
For a sample configuration, refer to
commands.
1
Configure the port channel to be used for the VLT interconnect on a VLT switch and enter interface
configuration mode.
CONFIGURATION mode
interface port-channel id-number
Enter the same port-channel number configured with the peer-link port-channel command in the
Enabling VLT and Creating a VLT
2
Add one or more port interfaces to the port channel.
INTERFACE PORT-CHANNEL mode
channel-member interface
interface: specify one of the following interface types:
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port[/
subport] information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
3
Enter VLT-domain configuration mode for a specified VLT domain.
CONFIGURATION mode
vlt domain domain-id
The range of domain IDs is from 1 to 1000.
4
Enter the port-channel number that acts as the interconnect trunk.
eVLT Configuration
Example. To set up the VLT domain, use the following
Domain.
Virtual Link Trunking (VLT)
1136
Advertisement
Table of Contents
Troubleshooting
