Enabling An Snmp Agent To Notify Syslog Server Failure - Dell S4048T Configuration Manual

On system
Table of Contents

Advertisement

SNMP OID <oid>
%RPM0-P:CP %SNMP-4-RMON_FALLING_THRESHOLD:
from
SNMP OID <oid>
%RPM0-P:CP %SNMP-4-RMON_HC_RISING_THRESHOLD:
threshold
alarm from SNMP OID <oid>
Enabling an SNMP Agent to Notify
Syslog Server Failure
You can configure a network device to send an SNMP trap if an audit processing failure occurs due to loss of
connectivity with the syslog server.
If a connectivity failure occurs on a syslog server that is configured for reliable transmission, an SNMP trap is
sent and a message is displayed on the console.
The SNMP trap is sent only when a syslog connection fails and the time-interval between the last syslog
notification and current time is greater than or equal to 5 minutes. This restriction also applies to the console
message.
NOTE:
If a syslog server failure event is generated before the SNMP agent service starts, the SNMP trap is
not sent.
To enable an SNMP agent to send a trap when the syslog server is not reachable, enter the following
command:
CONFIGURATION MODE
snmp-server enable traps snmp syslog-unreachable
To enable an SNMP agent to send a trap when the syslog server resumes connectivity, enter the following
command:
CONFIGURATION MODE
snmp-server enable traps snmp syslog-reachable
Table 85. List of Syslog Server MIBS that have read access
MIB Object
dF10SysLogTraps
The following example shows the SNMP trap that is sent when connectivity to the syslog server is lost:
DISMAN-EVENT-MIB::sysUpTimeInstance = Timeticks: (19738) 0:03:17.38
MIB::snmpTrapOID.0 = OID: SNMPv2-
SMI::enterprises.6027.3.30.1.1.1
STRING: "NOT_REACHABLE: Syslog server
10.11.226.121 (port: 9140) is not reachable" SNMPv2-SMI::enterprises.
6027.3.6.1.1.2.0 = INTEGER: 2
OID
1.3.6.1.4.1.6027.3.30.1.1
STACKUNIT0 falling threshold alarm
STACKUNIT0 high-capacity rising
Object Values
1 = reachable2 =
unreachable
SNMPv2-SMI::enterprises.6027.3.30.1.1 =
Simple Network Management Protocol (SNMP)
Description
Specifies whether the
syslog server is reachable
or unreachable.
SNMPv2-
990

Advertisement

Table of Contents
loading

Table of Contents