Table of Contents
Advertisement
FRRP Configuration
These are the tasks to configure FRRP.
•
Creating the FRRP Group
•
Configuring the Control VLAN
•
Configure Primary and Secondary ports
•
Configuring and Adding the Member VLANs
•
Configure Primary and Secondary ports
Other FRRP related commands are:
•
Clearing the FRRP Counters
•
Viewing the FRRP Configuration
•
Viewing the FRRP Information
Creating the FRRP Group
Create the FRRP group on each switch in the ring.
To create the FRRP group, use the command.
•
Create the FRRP group with this Ring ID.
CONFIGURATION mode
protocol frrp ring-id
Ring ID: the range is from 1 to 255.
Configuring the Control VLAN
Control and member VLANS are configured normally for Layer 2. Their status as control or member is
determined at the FRRP group commands.
For more information about configuring VLANS in Layer 2 mode, refer to
Be sure to follow these guidelines:
•
All VLANS must be in Layer 2 mode.
•
You can only add ring nodes to the VLAN.
•
A control VLAN can belong to one FRRP group only.
•
Tag control VLAN ports.
•
All ports on the ring must use the same VLAN ID for the control VLAN.
•
You cannot configure a VLAN as both a control VLAN and member VLAN on the same ring.
•
Only two interfaces can be members of a control VLAN (the Master Primary and Secondary ports).
•
Member VLANs across multiple rings are not supported in Master nodes.
Layer
2.
Force10 Resilient Ring Protocol (FRRP)
405
Advertisement
Table of Contents
Troubleshooting
