Configuring Management Vrf - Dell S4048T Configuration Manual

Table 98. Configuring VRRP on a VRF
Task
Create VRF
Assign the VRF to an
interface
Assign an IP address to
the interface
Configure the VRRP
group and virtual IP
address
View VRRP command
output for the VRF vrf1

Configuring Management VRF

You can assign a management interface to a management VRF.
1 Create a management VRF.
CONFIGURATION
ip vrf management
2 Assign a management port to a management VRF.
VRF MODE
interface management
Command Syntax
ip vrf vrf1
ip vrf forwarding vrf1
ip address 10.1.1.1 /24
no shutdown
vrrp-group 10
virtual-address 10.1.1.100
show config
-----------------------------
!
interface TenGigabitEthernet 1/13
ip vrf forwarding vrf1
ip address 10.1.1.1/24
!
vrrp-group 10
virtual-address 10.1.1.100
no shutdown
show vrrp vrf vrf1
------------------
TenGigabitEthernet 1/13, IPv4
VRID: 10, Version: 2, Net:
10.1.1.1
VRF: 2 vrf1
State: Master, Priority: 100,
Master: 10.1.1.1 (local)
Hold Down: 0 sec, Preempt: TRUE,
AdvInt: 1 sec
Adv rcvd: 0, Bad pkts rcvd: 0,
Adv sent: 43, Gratuitous ARP
sent: 0
Virtual MAC address:
00:00:5e:00:01:0a
Virtual IP address:
10.1.1.100
Authentication: (none)
Command Mode
CONFIGURATION
VRF CONFIGURATION
Virtual Routing and Forwarding (VRF) 1193