Sample Configuration Process; Device Setup Requirements; Initial Connection - Dell PowerConnect 3324 User Manual

console(config)# username admin password admin level 15
console(config)# exit
Enter the following commands once when configuring a console, a telnet, or an SSH session in order to use an HTTPS session.
NOTE: In the Web browser, enable SSL 2.0 or greater for the content of the page to appear.
console> enable
console# configure
console(config)# crypto certificate generate key-generate
console(config)# ip https server
console(config)# exit
When initially enabling an HTTP or HTTPs session, enter admin for user name and user1 for password.
NOTE: HTTP and HTTPS services require level 15 access and connect directly to the configuration level access.

Sample Configuration Process

The purpose of this chapter is to present the basic steps required in order to establish a remote network management connection with the PowerConnect
3324/3348 device. This chapter does not explain the various configurations available on the device or the relevant commands.
This chapter describes accessing a device for the first time—still with the factory configuration and definitions. If a previously entered configuration causes
problems, the startup-configuration file (configuration of device when powered up) should be erased and device rebooted, see

Device Setup Requirements

The following components are required for the purpose of this example:
PowerConnect 3324/3348 device
l
PC workstation with the following installed:
l
A NIC (network adapter) card installed
¡
An ASCII terminal application (for example Microsoft® Windows® MS Hyper Terminal or Procomm Plus Terminal)
¡
A browser application
¡
One Null Modem F2F cable.
l
Straight or cross UTP (cat 5) cable(s)
l

Initial Connection

The initial connection is as follows:
"Device Default Settings".