Table of Contents
Advertisement
6
Optionally, set full- or half-duplex.
INTERFACE mode
duplex full
7
Disable auto-negotiation on the port.
INTERFACE mode
no negotiation auto
If the speed was set to 1000, do not disable auto-negotiation.
8
Verify configuration changes.
INTERFACE mode
show config
Example of the show interfaces status Command to View Link Status
NOTE:
The show interfaces status command displays link status, but not administrative status. For
both link and administrative status, use the show ip interface command.
Dell#show interfaces status
Port Description Status Speed
Te 1/1
Down
Te 1/2
Down
Te 1/3
Down
Te 1/4 Force10Port Up
Te 1/5
Down
Te 1/6
Down
Te 1/7
Up
Te 1/8
Down
Te 1/9
Down
Te 1/10
Down
Te 1/11
Down
Te 1/12
Down
[output omitted]
In the previous example, several ports display "Auto" in the Speed field. In the following example, the speed of
port 1/1 is set to 100Mb and then its auto-negotiation is disabled.
Dell#configure
Dell(config)#interface tengig 1/1
Dell(conf-if-te-1/1)#speed 100
Dell(conf-if-te-1/1)#duplex full
Dell(conf-if-te-1/1)#no negotiation auto
Dell(conf-if-te-1/1)#show config
!
interface TenGigabitEthernet 1/1
no ip address
speed 100
duplex full
no shutdown
Duplex Vlan
1000 Mbit
Auto
Auto
Auto
Auto
Auto
1000 Mbit
Auto
Auto
Auto
Auto
Auto
1000 Mbit
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
1
1
--
30-130
--
--
1502,1504,1506-1508,1602
--
--
--
--
--
Interfaces
489
Advertisement
Table of Contents
Troubleshooting
