Table of Contents
Advertisement
____________________________________________________________________________________________
1.3 Hardware Assembly
The Dreamer comes pre-assembled and is almost ready-to-print (ARP). All
you need to do is set the appropriate voltage, mount the extruder set, and
install the filament. It will only take between 5 to 10 minutes before you
can fire up the Dreamer and prepare for your first 3D print!
PRECAUTION:
FlashForge Dreamer uses a switching power supply with 115V/230V.
Prior to installing the hardware, it is critical to check the AC output voltage
of your home or workplace. The power supply should be switched to
reflect your AC output voltage. Failure to do so will cause severe damage
to the Dreamer. Please follow the steps below to switch to the correct
voltage.
For the United States and Canada, the correct voltage to use is 115V. For
most
European countries, use 230V.
FLASHFORGE will not be responsible for damages as a result of
improper care.
Dreamer User Guide |
www.ff3dp.com
Please
double-check as
16
Advertisement
Table of Contents
