Chapter 4: Hardware Assembly; Filament Installation - Flashforge Finder User Manual

Chapter 4: Hardware Assembly

Your Finder has been installed before leaving factory, you can start up the Finder for
printing after mounting the filament spool and completing leveling.

4.1 Filament Installation

(4-1) The filament cartridge is at the rear of Finder. Lift the cartridge out of the Finder.
(4-2) Take out the filament and thread it through the filament detecting equipment.
(Note: The filament should feeds from the bottom of the spool towards the top )
Finder User Guide | www.flashforge.com
4-1
4-2
28
The black part isFilament
Detecting
E ip
400-699-1063