Flashforge Dreamer Desktop 3D Printer User Manual page 48

____________________________________________________________________________________________
10. Now the Dreamer is connected with FlashPrint. A status box at the
lower right corner will show the temperature of both extruders and the
Platform.
11. In FlashPrint, click
Make sure that "ABS" is selected under
Advanced settings can be set by clicking on
12. Check the box of
13. Save the file at any location, and the object will start slicing.
14. After the object is done slicing, it will automatically upload the gcode
to the Dreamer.
15. After the gcode is done uploading, the printer will go into a preheat
phase. The Dreamer will start printing once preheating is finished.
NOTE: Printing from SD card is unavailable when WIFI is ON.
Printing with Support
1. If the 3D model has excessive over-hang, then support will be needed.
2. In the Slice options screen, select from "Supports" the left or right
extruder.
3. Click [ OK ] to begin slicing.
Dreamer User Guide |
[ Print ]. A printing options screen will appear
"Print When Slice
www.ff3dp.com
"Material Left."
[ More Options
Done," and hit [ OK
].
].
48
44