Flashforge Dreamer Desktop 3D Printer User Manual page 7

____________________________________________________________________________________________
General Safety Warnings
PRECAUTION:
Prior to powering on the Dreamer, make sure the power supply switch is set
to 115V if you are located in the United States and Canada. For other
countries, please refer to your country's AC output voltage. Failure to do so
will damage the mainboard . For instructions on how to do this, please refer
to page 14.
Please make sure to read this section carefully prior to setting up
and operating the Dreamer.
! Ensure that your Dreamer is earthed lest electrostatic interference.
! Turn off the machine and unplug the power cable before doing
maintenance or modifications.
! Always avoiding to touch the nozzle and the plate during operation.
! Only use your Dreamer in a well-ventilated area. (When printing ABS,
small concentrations of Styrene vapor can be released. This may (in some
cases) make you uncomfortable.)
! Do not leave the Dreamer unattended when during operation.
! Do not leave the Dreamer unattended when in operation.
Dreamer User Guide | www.ff3dp.com
7