Flashforge Dreamer Desktop 3D Printer User Manual page 47

____________________________________________________________________________________________
5. Click on [ Work Mode ]
"AP+STA mode" and save it.
6. Click on [ STA Setting
a working network,
corresponding password and save.
7. Restart the interface, close the page,
turn off the Dreamer, disconnect from
the network, and wait for 10 seconds.
8. Turn the Dreamer back on and
connect to the Dreamer network. In
FlashPrint, choose
and select [ Connect
9. Under "Connection
Wi-Fi, and enter the
Port" as shown on printer LCD screen.
Then, click [ Connect
Dreamer User Guide |
and choose
], select
enter
[ Print ] from menu
].
Mode", select
"IP Address,
].
www.ff3dp.com
the
47