Hardware Assembly - Flashforge Guider II Quick Start Manual

1. Locate the spool holders.
Install the spool
holders in the two quadrangular openings on
the back.
To install a spool holder, level it and
insert the end into one of the openings.
3. Squeeze the spool holder top and mount the
filament spool to the holder.

Hardware Assembly

2. Turn down the spool holder to make the holder
bottom cleave to the printer back.
4. Secure the filament guide tube with R-shaped
buckles and thread the filament through the
tube. The filament spool must be oriented
correctly (see above), and should feed
filament from bottom to top.
05